PC200 PC210 PC220 PC230 PC240 Excavator Attachment Rotary Hydraulic Grab Bucket Grapple

Product AppliCATEEEEion
1. Log grabbing,moving and organizing.
2. Stone grabbing,moving and organizing.
3. Other large scraps grabbing,moving and organizing.

How to choose the grapple model?
1. What is your excavator model or tonnage?
2. What material do you want to grab? Stone, wood, Rubbish or something else?

PC200 PC210 PC220 PC230 PC240 Excavator Attachment Hydraulic Grapple Bucket Rotary Hydraulic Grab Bucket Grapple

Product Maintenance
1.Daily checkpoint: Whether there is any damage or deformation of the body, hose interface leakage, damage to the pin and bushing and its replacement
cycle,check the oil level of the gear, check the bolt and nut, the gear
tightening loose state.
2.Conventional checkpoint: The seals and rotating parts of the hydraulic
cylinder will wear out, and should be replaced in time after reaching the
service life. Replacement parts should be matched with the original factory. Check the rotating shaft in 360 degrees,whether easy to work from any
Angle, check that there is enough lubricant on the rotating shaft and bolts
are tight enough.
3. Check the tightening state of bolts, install new bolts, check 8 hours after
use, and ensure that the tightened bolts are not loose. Damaged bolts
should be replaced in time. Bolts should be replaced after approximately
1500 hours or 12 months of use after installation.
4. It is recommended to check whether there is oil leakage regularly to
ensure that there is no fault and the product can run smoothly. Every 4 hours: fill lubriCATEEEEing oil, lubriCATEEEEe shaft pin and rotating gear once;
Every half year or 1000 hours (whichever comes first) : Replace the hydraulic
cylinder oil seal and motor oil seal once.

Our Hydraulic Rotary Steel Grapple Product SpecifiCATEEEEion

Product Features


 
We Can Supply Following Excavator Model Attachments